Just a quick question to fellow gen 7 owners.
It looks like the rubber windshild molding is a little loose on the passenger side. Actually it was loose on the driver's side too, but i moved it about a bit and it popped in nice so there's hardly any motion now.

however i can't do the same for the passenger side, so it's looser than the driver's side now, i can move it up and down (but not from side to side, so there's some engagement there)

i can see the plastic clip under the rubber corner piece and they seem to be different...the driver's side is blue and the pass. side one is white. Also the driver's side has an edge that goes over the windshield which keeps it snug. the white clip on the passeger side doesn't seem to.

anyhow, would that differnce be normal or perhaps the clip is not engaged or broken?

I'm not seeing any evidence of different sizes per side......:dunno:

hm...definitely different on different sides. on the passenger side i can pull the molding off and see the edge of the windshield glass, on the drivers side the rubber molding rests on a strip of plastic that rests on glass, hence i can't push the molding in the same as on the passenger side.