I just bought a set of eibach pro kit springs on ebay.... lower car between one and one and half inches.... has anyone here had these installed? if so, what were your alignment specs? trying to find out if a camber correction kit is needed or if camber stays pretty close on 7th gens.. any input???

Honda's alignment specs for the HFP suspension are in the link below. if its out of those specs (which i think they will be) then you need at the very least a rear camber kit. i believe the front camber is somewhat adjustable already. :confused:

if its within the HFP specs, then its up to you to get a camber kit or not, but it will still cause some accelerated inside tire wear, even though it wont be very severe.

http://www.v6p.net/forums/showthread.php?t=46005

If the rear is -2 degrees, I'll be getting a kit... that'll wear tires too fast for me. and nope. front isn't adjustable at all, but I think it is less reactionary to lowering than the rear...... thanks for the link for the specs. :)

just got rear camber kit on ebay cheap. problem solved. :) untill wife finds out. :(

On my 03 coupe, I have Eibach prokits as well.....need the rear control arm.

Got mine from a local shop here:

SPC for about $63 each.

http://www.spcperformance.com/

I got the ingalls rear kit, with camber and toe arms for $145 I think. do you know where the front camber was after install???? did you install correction in the front?

installed pro kit and ingalls rear camber kit today... talk about easy install. easiest I've done yet. look great, aligned perfectly..... rides slightly rougher, but not bad at all. will post pics tomorrow....