my 03 accord has the following problems:
clutch makes noise, and clicks on release.
passenger seat seem to be attached only on one side which causses it to swival slightly.
the dealer (cush honda) claims that all accords a built this way and nothing can be done about this.

Is your car one with power seats?

no, i have an accord dx with manual seats.

I searched in the service bulletins for any seat things & came up with nothing for yours. Wiggly seats aren't normal & it may be that some of the fasteners aren't torqued down completely. Have you checked for loose bolts? I know they should have & if you complain I'm sure they will.

I'll check about clutch noise later.

the only thing I found were all on AT's. There's a whole bunch of things going on there! Scary for me, that what I have! There was nothing for manuals.

sorry

If they come out with a bulletin on your problem I'll pass it on.

Originally posted by princess
the only thing I found were all on AT's. There's a whole bunch of things going on there! Scary for me, that what I have! There was nothing for manuals.

sorry

If they come out with a bulletin on your problem I'll pass it on.

hi princess,

what type of AT problems are you referring too? anything to be worried about i own a AT 4 banger 2003

regards

The next post will be a copy of the letter the owners should have received if they have the required VIN#.



Service Bulletin
 2003 American Honda Motor Co., Inc. – All Rights Reserved ATB 25279 (0307) 1 of 2
CUSTOMER INFORMATION: The information in this bulletin is intended for use only by skilled technicians who have the proper tools, equipment,
and training to correctly and safely maintain your vehicle. These procedures should not be attempted by “do-it-yourselfers,” and you should not assume
this bulletin applies to your vehicle, or that your vehicle has the condition described. To determine whether this information applies, contact an
authorized Honda automobile dealer.
July 31, 2003
03-042
Applies To: See VEHICLES AFFECTED
Product Update: No-Reverse Condition
BACKGROUND
If a vehicle is stuck in snow and the transmission is
shifted several times between a forward drive gear and
reverse (at wheel speeds above 12 mph), a no-reverse
condition can develop.



VEHICLES AFFECTED
2003 Accord L4 A/T 2-Door:
From VIN 1HGCM72..3A000001
thru 1HGCM72..3A023877
2003 Accord L4 A/T 4-Door:
From VIN 1HGCM56..3A000001
thru 1HGCM56..3A080789
From VIN 3HGCM56..3G700001
thru 3HGCM56..3G705659
From VIN JHMCM56..3C000001
thru JHMCM56..3C077295
Not all vehicles within the VIN ranges are affected by
this product update. Before beginning work on a
vehicle, verify its eligibility by checking at least one of
these items:
• The customer has a notification letter.
• The vehicle is shown on your campaign
responsibility report.
• The vehicle is shown as eligible on an i N VIN status
inquiry.
If any affected vehicles are in your new or used
inventory, repair them as described in this service
bulletin.
CUSTOMER NOTIFICATION
All owners of affected vehicles will be sent a
notification of this product update. The customer
notification may also contain information on other
product updates. An example of the customer
notification for this no-reverse product update is at the
end of this service bulletin.
CORRECTIVE ACTION
Update the PCM with the Honda Interface Module
(HIM).
WARRANTY CLAIM INFORMATION
Operation Number: 125518
Flat Rate Time: 0.7 hour
Failed Part: P/N 37820-RAA-A54
H/C 7284607
Defect Code: 5CR
Contention Code: L99
Skill Level: Repair Technician
REPAIR PROCEDURE
1. If not already done, load the July 2003 or later i N
network CD onto the i N master terminal. Loading
instructions were included along with the CD’s
mailing
2. Update the PCM with the HIM (see service bulletin
01-023, Using the Honda interface Module to
Update Control Units/Modules).
3. Connect the Honda Diagnostic System (HDS) to
the vehicle’s data link connector (DLC). Use the
HDS to clear any body electrical codes that may
have been set during the PCM update.
4. Cycle the ignition switch to LOCK (0), and then to
ON (II). Use the HDS to see if the body electrical
codes have returned.
• If the codes have returned, do the appropriate
troubleshooting procedure(s) in the 2003 Accord
Service Manual, then go to step 5.
• If the codes are gone, go to step 5.
5. Make sure all electrical accessories (A/C, radio,
lights, etc.) are off, then start the engine, and let it
run until it reaches normal operating temperature
(the cooling fans cycle twice).
6. Let the engine idle for 10 minutes.
7. Center-punch a completion mark above the ninth
character of the engine compartment VIN.
Center-punch here.
1HGCXXXXXXXXXXXXX

I've seen the "transmission swap under warranty" instructions. We change our tranny fluid as often as the engine oil. The reason is that the MDX & some other's with the same tranny as the V6 have problems caused by particals in them from normal wear. They no longer have an external filter. We planned on adding a filter, but in the mean time we're changing it real often! For our Hondas, we change it 5K. It's just easier for us than the 7500 on the oil. We have a mixture of driving conditions & we'd rather over do it than under do it!


August 2003
Product Update: No-Reverse Condition
Dear Accord Owner:
This notice has been sent to inform you of a potential
problem with your vehicle and what you should do to
resolve it.
What is the problem?
If your vehicle gets stuck in snow and you shift the
transmission several times between a forward drive
gear and reverse (at wheel speeds above 12 mph), a
no-reverse condition can develop.
What should you do?
Call any authorized Honda dealer, and make an
appointment to have your vehicle updated. The dealer
will update the powertrain control module on your
vehicle. This work will be done free of charge. Please
plan to leave your vehicle at the dealer all day to allow
them flexibility in scheduling.
What to do if you feel this notice is in error.
Our records show that you are the current owner or
lessee of a 2003 Accord involved in this product update.
If this is not the case, or the name/address information
is incorrect, please fill out and return the included,
postage-paid Information Change Card. This will help
update our records.
If you have questions.
If you have questions about this notice, or need
assistance with contacting a Honda dealer, please call
Automobile Customer Service at (800) 999-1009.
We apologize for any inconvenience this update may
cause you.
Sincerely,
American Honda Motor Co., Inc.
Honda Automobile Division
Example of Customer Letter