Im trying to install my sub and amp. I couldnt find a hole on the firewall to run the power wire. Dont want to drill any holes on a brand new car too. Help :dunno:

check if you can run it inside your fender ..take off the plastic thingy and look for black plugs you can pull 1 off and run it in there and use silicone to make sure a water tite fit

http://www.gixxer.com/uploads/DSCN2351.JPG

see the blue wire, line? See if it will fit there. This is under the driver side dash, right side of the steering wheel. wee

http://www.gixxer.com/uploads/DSCN2352.JPG
Blue hose.
weee

I didnt look real good to see if the hole is large enough, but there is a hole there. lol. wee

Thanks. I'll check on that tomorrow. If not I'll just force it in with the harness :notworthy

Thanks. I'll check on that tomorrow. If not I'll just force it in with the harness :notworthy


yepper. weee

check if you can run it inside your fender ..take off the plastic thingy and look for black plugs you can pull 1 off and run it in there and use silicone to make sure a water tite fit

Yea, this is how I'm going to do my install. I'll snap some pics for everyone. I had some old 8" Bazookas (one powered, one slave) and I replaced the subs with some new Fosgates. Ran all the trunk wiring using corregated tubing so it looks stock and used the signal from the rears.

Didnt have time to run the power and remote wire. I was trying to figure out how to remove the driver side floor panel thingy (forgot what the was called), you know, the plastic that covers the wiring and houses the gas trunk lever. Anybody know how to remove this? I suspect I just need to yank and pop it off, but I want to be sure before I do this...Thanks...

Yea, this is how I'm going to do my install. I'll snap some pics for everyone. I had some old 8" Bazookas (one powered, one slave) and I replaced the subs with some new Fosgates. Ran all the trunk wiring using corregated tubing so it looks stock and used the signal from the rears.

Didnt have time to run the power and remote wire. I was trying to figure out how to remove the driver side floor panel thingy (forgot what the was called), you know, the plastic that covers the wiring and houses the gas trunk lever. Anybody know how to remove this? I suspect I just need to yank and pop it off, but I want to be sure before I do this...Thanks...


Pull but don't pull too hard. It breaks.

It took me more than an hour to find a hole to run my power wire when I installed my basslink last week. On mine, if you look near the center of the firewall, about 1ft from the top, there is a grommet (I looked from the left side of the engine compartment). Take the grommet out and reach a finger in there. Search for the hole between the two cloth-like material and try to sorta open it up. Then stick your wire in and slowly work it into that hole. Push the wire through and you should see it come out to the right side of your gas pedal.

I then ran my wire through the center console, under the driver seat, and through the driver side to the trunk.

Enzo