BenjiBoy650
05-23-2004, 05:14 PM
I read the manual and it gave me directions on how to replace the front turn signal bulbs. What they didn't tell me is that apparently your arms need to be the size of chopsticks to fit into the little opening that you're given when you pull back the fender liner as instructed. What else can I do? I don't know how to get the other clips off, and that bulb is really far away and not accessible from the engine bay.
It's pretty ridiculous how far they went to cost cut. When I tried to put the fender liner back, the screw that I'd took out earlier pushed the rubber receptor right out of place and basically now I can't get it back in. I don't know whatever happened to just using screws to secure this kind of stuff...
It's pretty ridiculous how far they went to cost cut. When I tried to put the fender liner back, the screw that I'd took out earlier pushed the rubber receptor right out of place and basically now I can't get it back in. I don't know whatever happened to just using screws to secure this kind of stuff...