Tips on Paint Chip Repair - Drive Accord Honda Forums

Go Back   Drive Accord Honda Forums > TECH Exchange > Articles - Body

Drive Honda Accord Forums
Closed Thread
 
Thread Tools Display Modes
  #1  
Old 03-03-2011, 06:48 AM
AF_Don AF_Don is offline
TECH Exchange Editor
 
Join Date: Oct 2010
Posts: 30
Thanks: 0
Thanked 4 Times in 4 Posts
Tips on Paint Chip Repair

Submitted by Dan (aka snomuncher)



I've had to repair a few paint chips on my silver 2005. Most metallic paints are difficult to match, with silver being one of the toughest. The metallic elements in the paint don't seem to lay down in the chip and provide the same reflectivity as the surrounding area. After a bit of experimentation using a variety of techniques, I found several tricks that helped quite a bit for the metallic silver.

One is to fair the edges of the chip into the surrounding area. Sharp edges are near impossible to color blend otherwise. This will enlarge the chip area but will produce a more uniform reflective repair as discussed below. I use a fiberglass nick sander to do this.



Another is to mix the base paint and clear coat together. This is an advantage because it allows the paint to lay into the chip level with the surrounding area, not requiring additional build up of the clear coat that will need to be sanded or buffed level with the surrounding area.

The third is to mix the paint to a viscosity that allows it to flow freely into the chipped area. Many touch-ups are lacquer-based and adding a drop or less of lacquer thinner onto a dab of paint-plus-clear mixture will thin the mixture enough to flow rather than have to be brushed on. This is where fairing in the sharp edges becomes an advantage; it allows capillary action to let the paint flow freely as if filling a small “pool.”

The last is to experiment with tools other than a brush for repairing chips. One size does not fit all repairs. The brush in the cap that is included with most touch-up paints is too large and holds too much paint for most minor chips, and will leave a "glob" on the surface that does not match well with the surrounding area. I have successfully used both flat and round toothpicks to flow paint into chips- and don’t use too much paint.

Patience is a virtue here and it may take several tries...removing the touch-up with lacquer thinner will allow you to start again if you’re not satisfied. Good luck.
Quick reply to this message
The Following User Says Thank You to AF_Don For This Useful Post:
drol343 (06-15-2014)
Sponsored Links
Advertisement
 
Closed Thread

Quick Reply
Message:
Options

Register Now

In order to be able to post messages on the Drive Accord Honda Forums forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
The answer to the random question may be found under the Off Topic section of the forums and in the "Drive Accord Forums" category.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -8. The time now is 09:31 PM.




Powered by vBulletin® Copyright ©2000 - 2014, vBulletin Solutions, Inc.