Drive Accord Honda Forums banner

6th gen

  1. The 6th Generation
    I am looking for wiring diagram for climate control unit of Honda Accord 2001 (1998-2002). If someone can list down the wires for me that would be great. it has a 20 pin connector and a 8 pin connector.
  2. Other Honda talk
    Hello everyone I have a ULEV F23A4 engine and automatic transmission 4 door lx 6th gen Accord 160,000 miles. I want to swap the engine for a H22 engine, I want to keep it as an automatic transmission too. but I am not sure where to start and what to get to complete this project. this will be a...
  3. The 6th Generation
    I'm wondering who is running larger-than-stock rims/tires on their 6th gen. Would like to size up to a slightly larger set from the stock 15" rims ?('00 Accord) but don't know the fitment implications. Anyone who's running a larger size, I'd love to see a pic and/or specs of your setup! Are you...
  4. The 6th Generation
    My daily driver ('01 CR-V) recently died and I'm looking to replace it. Came across an '00 Accord with manual trans, 262k miles. Current owner seems to have taken really good care of the care over the last 7-8 years. Within the last 30k miles he has replaced with OEM parts: front brake lines...
  5. The 6th Generation
    Hi all, My 2002 EX-L has 333,333 miles on it (1st owner), on a 2nd transmission, first one replaced at 207k. 3 months ago check engine light turned on, it was code 0700 and 0740. I have been driving it since and haven't noticed any transmission failure symptoms. The car still shifts smoothly...
  6. DriveAccord Classifieds
    Hello, Looking for basically any 4x114.3 that has close to the correct offset for a 6th gen Accord. I just bought one (the car) and it has aftermarket wheels that stick out past the fender :grumpy: Not looking for anything fancy. Steelies are fine and rim diameter doesn't matter either (as...
  7. The 6th Generation
    I'm finally giving Dirty Girl the TLC she needs, and she's not AS dirty anymore! So, I figured, why not make a thread for her? :) I installed a lot of what is in this box, and more needs to get installed still. Driver side spray nozzle It's hard to see, but you can see the hyper...
  8. The 6th Generation
    Okay guys and gals, I have a 01 accord ex v6 with 17X,XXX miles give or take and i had recently been having issues with accelerating. I would go to floor it at 35 mph or so and it would just rev and barely accelerate but sometimes it would go. I was throwing codes for my TPS and MAP sensor that...
  9. The 6th Generation
    So I'm not too sure if anyone has ran into this problem or its just built into this year and model accord but does anyone else's 6th gen accord doors lock automatically when closing the driver door? Let me note that the drivers door does not unlock when using the power door switch to unlock the...
  10. The 6th Generation
    Hi Everyone, 2000 Accord Coupe My floor jack in no way has enough reach to lift the tires off the ground (esp the rear; the front works barely). I don't want to invest in another floor jack or mess with other techniques I have seen other people use. So I'm looking to lift it off other points...
  11. Problems & Solutions
    hi everyone, 2000 accord 2.3l, 185x so i know how to do valve adjustments. but on my car, on certain valves (cyl 1 and 2, primary rocker arms), i cannot get the valve adjustments to stay put. for e.g. i adjust it to a certain spec, tighten it and when i rotate the engine and check it again...
  12. The 6th Generation
    hi everyone, so i needed to replace my valve cover and i went to the junkyard and got several of them without looking at the exact model [though they were all 6th generations] they all look the same [except one says 5w20]. when i look on the honda parts website, all of the 6th gen valve...
  13. The 6th Generation
    Hey, happy Friday all! I have found myself recently in the market for a suspension upgrade for my car. I have found a lot of useful information out on the web, but I am increasingly weary about reviews these days...anyhow, what applications have you guys used to drop your car? I am on a budget...
  14. The 6th Generation
    So recently my 1999 Honda accord 4cyl with 97,500 miles will stall randomly, while slowing down for a red light or turning into a driveway, it usually catches itself before I come to a complete stop. the 1997-1999 Accord, Ignition Switch Recall was done in 2002 by the previous owner. do you guys...
  15. The 6th Generation
    Hey guys, been seeing more and more of these Red JDM badges around and I was wondering where I can get some. I've been all over eBay but can't find the exact sizes for the front and rear emblems on my 6th gen 2DR coupe. If any of you out there have website links or have any info on this post it...
  16. The 6th Generation
    Hi guys I recently bought a dual led emblem light off of ebay and am having some trouble figuring out how to wire it so that it is connected with the brake/license plate lights. If anyone has done this before your help is greatly appreciated! :banana::) 2001 Honda Accord EX V6
  17. The 6th Generation
    I have owned this car for three years now, and I have fallen in love with it. It most recently started what I guess you would call "double engagement?" I noticed last week when putting the car into drive my engine jerks, it has always slightly jerked which is normal, but it started doing a...
  18. The 6th Generation
    I just bought some LED tail lights for my 4dr 6th gen accord. I installed them fairly easily and connected all the wires without any problems. But I do have a problem; when i turn on my lights the LED's work perfectly and all my tail lights work for that matter. But when I press on my brakes...
  19. Audio & Electronics
    I decided to install a car computer in my 99 Accord about a month ago, and so far it's turned out fairly well. Here are a few pictures: This is the problem area: Also, I how do I got about removing this panel? I might be wanting to run a wire up to the rear view mirror: When cutting...
  20. Modify
    I was looking for HIDs but did not want to produce a glare for other drivers, and I ended up picking these headlights up. Installed these 2 months ago and so far they have been working without a problem. I'll try posting cut off pics soon. What do you think? :yes:
Top