Drive Accord Honda Forums banner

bolt

  1. The 7th Generation
    So I was putting the tensioner back on my 2006 Accord 4cyl. after fixing a code P1009 and as I was tightening the the rear bolt of the tensioner the broke off. I believe part of the boat is still holding the tensioner on however the other two bolts are secure and the tensioner doesn't seem to...
  2. DIY
    I was replacing my struts in my 2003 LX I4 when the head of a bolt on this part came off. Calling every parts store in my area, no one could understand what I was talking about. I'm referring to the horse-shoe shaped, wishbone looking, forked piece that the bottom of the strut slides into...
  3. The 9th Generation
    So my driver side seat has creaked from day 1, but finally got around to checking the bolts. The left side are tight, but the right side were loose (would guess ~10 ft lbs). Does anyone also have this problem, and any chance someone has the torque spec? So far this is the only poor...
  4. The 6th Generation
    Hey everyone. First post here, so please tell me if this is the right place to post. I have a 2001 Honda Accord. I just replaced the front motor mount. Everything fits great and works fine, but the center bolt that goes into the aluminum support beam (?) broke off inside the engine block...
  5. Problems & Solutions
    89 accord. front left coil spring is broken so went to change both. Problem is I can't get the suspension fork bolt off (the one at the bottom of the fork). I've got the nut off and tried wailing on the bolt with a hammer. Tried hitting it while supporting the lower arm with a jack and while...
  6. Problems & Solutions
    Hello guys, I am new here. Long Story Short: Bought a used Accord 2000 lx coupe manual...with problems, repair bills too high, trying to learn how to repair things myself. And then yesterday, I was cleaning my air cleaner housing (just under the filter where there was sand and a lot of dirt...
Top