Drive Accord Honda Forums banner
gasket
1-8 of 9 Results
  1. The 8th Generation
    Hi guys, I have an oil leak & need help figuring out which gasket I need to replace. Not too familiar with a lot of these gaskets. Every time I do a cold start, oil leaks from around the dipstick area above the alternator and oil is dripping slowly into the alternator. I’m afraid if I don’t...
  2. The 7th Generation
    I noticed an oil leak coming from around the Vtec (spool) valve in my 05 Accord at about 120K miles. The oil went all around the drive pulley and below the vtec valve assy, but never on ground. I followed the instructions I found in various threads on this forum and in the service manual to get...
  3. Problems & Solutions
    I have a 99 Accord EX V6 SOHC. I know that my valve cover gaskets are bad and I'm going to replace them myself, however.....I am getting cylinder misfire codes and I believe it's because there is oil dripping on my spark plugs. Should I replace or just clean off my spark plugs? They are only...
  4. The 6th Generation
    hi everyone, so i have had a valve cover leak for 5 years (timing belt changed 6 years/45x miles ago) and i ignored it until recently. just to check i also removed the upper timing belt cover and this is what I found. Is this anything to worry about? The timing belt itself is completely dry...
  5. The 7th Generation
    Hello ladies and gents, Its Friday, payday, the best day of the week. I got my TSX IM In yesterday and this morning I went to Autozone for a couple supplies to prep and install the bouger. So Autozone carries a brand by the name of Fel-Pro for the price of $17.99 US, but I have read numerous...
  6. The 7th Generation
    I have a 2004 Accord v6 and the rear valve cover is leaking. I called a shop and they want $410 to do the work. That seemed really high to me so I'm going to do it myself. the service manual says that I need to remove the intake manifold. I can't find the diagram for removing the intake manifold...
  7. The 8th Generation
    I've just recently started getting into tuning. I've only had my 6-6 for a few months now. I have a Takeda SRI and just ordered a P2R throttle body and 1 throttle body gasket last night. After doing some reading this morning, my question is: Should I have ordered 2 gaskets???
  8. The 7th Generation
    I'm preparing to do the TSX Intake Manifold swap and I know there are some gaskets that should be replaced when I do it. So which gaskets should I replace? Just the IM gasket or also the throttle body gasket? And which one should I get? I have no idea which TB gasket to get. As for the IM...
1-8 of 9 Results
Top