Drive Accord Honda Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 7 Results
  1. The 9th Generation
    Got hit passenger corner car still ran ok i did not hear any weird noises but did notice this was leaking
  2. The 8th Generation
    On a new (to me) 2008 K24 with 130,000 miles, I noticed oil seeping out of the VTC control valve area, so I replaced it with the R5A version. Last night I noticed it is still leaking as much if not more oil than before. Looking at several videos, I wonder if the leak is actually between the...
  3. The 7th Generation
    Hello all, I recently took my 2003 Accord Coupe V6 into the shop. I told them that the A/C is cold on the driver's side, but not on the passenger's side. The mechanic called me and told me that the low pressure side was low/out of refrigerant. He recharged it, and my A/C was ice cold on both...
  4. The 8th Generation
    Hello Looking at a 2012 Accord, 4cyl, Automatic, 4 door, noticed no transmission cooler lines. I can see the hookup/nipples on bottom of radiator but no trans lines hooked to it. They are just sticking out of radiator. Did they do away with trans cooler lines in the 2012? I did...
  5. The 9th Generation
    I searched and found someone else with a 9th gen and a leaky trunk in a touchless wash, but that car had been in an accident. My car has not been in an accident, and I didn't have any issues last winter when going through the touchless wash, but this winter I'm getting a fair bit of water on...
  6. The 7th Generation
    The drain bolt on my oil pan is leaking. I just changed the oil. It's not even 500 miles old. I know it's the crush washer. Is there anyway I can change the washer without letting all of the oil out? I need to remove the plug to change the washer obviously. ty
  7. The 6th Generation
    I have a 2000 V6, and I think there is a problem with one of my lower ball joints. The lower control arm near the joint is stained, so I think the grease is slowly leaking out. I deduce that I need to replace the boot on this ball joint. Is this a correct assumption? I'm hoping the grease...
1-7 of 7 Results
Top