Drive Accord Honda Forums banner

lighting

  1. Audio, Electronics & Lighting
    I've been trying to find it but I can't find it some sort of discussion. If I wanted to get the LED daytime running lights on to a four cylinder exl would it be possible. The fitment is the same the only difference is the 2 and 3-pin connections for the light at the bottom of the assembly. Are...
  2. Audio, Electronics & Lighting
    Tail lights don’t work fuse and bulbs are good I have a short somewhere or bad ground. I have power at my trailer harness which means my trailer lights work if it were hooked up? I do not know why I have no power at my tail light socket when I turn on my lights Headlights tail lights should come...
  3. Audio, Electronics & Lighting
    Hi everyone, this is my first post on DA, so please bear with me I recently purchased a used 2009 Honda Accord EX-L V6. Before purchasing, I noticed that the right turn signal would blink 2x as fast as the left. I initially thought this was a dying/incorrect bulb that simply needed to be...
  4. Audio, Electronics & Lighting
    I've been wanting to purchase the Vland Tail Lights for the 9th gen accord but they're only compatible with the 13-15 models. BUT, I've seen people with 16-17 models with these installed and was wondering if anyone had done this or knew how to go about it? I know I'll need to also purchase the...
  5. Audio, Electronics & Lighting
    Hello everyone, I'm very new to this forum site, I've just picked up a 2014 Accord Coupe EX-L 6MT. I'm having an unusual amount of time figuring out why my interior lights(both map and dome) remain on even when i have set them to the "door" setting. They should turn off atleast when the vehicle...
  6. The 9th Generation
    Has anyone figured out a wiring scheme that allows rear LED reflectors in the lower bumper to be wired to switch on/off with the fog lamps?
  7. Audio, Electronics & Lighting
    I've been looking to upgrade the low beams on my 16 Sport, I am currently considering two brands, DDM tuning (Ultras 55w $100) and Morimoto ($165 50w) At the moment i will not be retro fitting the projectors and I understand the downfalls of H.I.D.'s in halogen projectors. Here's my question...
  8. Audio, Electronics & Lighting
    Anyone know the temperature of the DRLs on the 2016 Accord Coupe EX-L? I want to put in some HID headlights but just wanna match the DRLs. DRL = daytime running lights
  9. Audio, Electronics & Lighting
    Hi all, I have an 09 coupe and the headlights have condensation in them and I believe it is causing me reduced visibility on the road. I am considering disassembling the components in the summer and then resealing. If all goes well I want to convert to an HID kit. I would like to know what kits...
  10. Audio, Electronics & Lighting
    There are so many places to choose from when it comes to interior/license plate lighting! -XenonDepot (dome/map for $35) -DiodeDynamics (everything $70-$100 I believe) -exLED (complete set for $90 but doesn't list lumens) -KBcarstuff (only dome lights for $69) -vLED (single purchases. 80, 160...
  11. Audio, Electronics & Lighting
    Hi guys, new either gen owner here. I just upgraded from my 6th gen after 5 years and bought an 08 accord coupe v6. The car came with a cracked fog light and I was looking to replace them and when I googled up which fog lights fit the car, two different ones came up. Do any of you guys know...
  12. Audio, Electronics & Lighting
    I finally frickin' did it. Woke up this morning and said "I'm gonna stop procrastinating!" I had everything wired up, and hanging on my door coat rack pretty much since I started this thread lmao. It's been really cold out the past month or so, and I've been taking different vacations and...
  13. Audio, Electronics & Lighting
    hey guys itst time for me to upgrade my lighting on my car but i dont know what to get. i am going with exLED Honda Accord 9th Gen, 13~14 (Map, Dome, Vanity, Trunk, License Plate + optional Door Lights) Custom interior kit and i will be buying there reverse lights and fog lights. does anyone...
  14. Audio, Electronics & Lighting
    2007 Honda Accord V6. Have LED strips for the footwells. What is the easiest way to wire them to come on with my low beams? Or how could I get them to stay on when I'm driving? Right now, as soon as I shift out of park they turn off until back in park. Any help is appreciated, thanks.
  15. Audio, Electronics & Lighting
    I am looking to install one strip of LED's into each of the footwells in my 04 Honda Accord LX. I want these LED's to have three positions: one for on, one for off, and one that pulses with the bass of the music. I am installing a new head unit because the old factory one has the back light...
  16. The 8th Generation
    hey guys, im getting a little complicated here but im brainstorming long and hard and finally realized i need some help. I plan to attach 3 smd led strips to each of my door handles underneath them in blue (pathway lighting/illumination). i want them to turn on obviously when i unlock my doors...
  17. The 8th Generation
    Hey guys i have the LX model and when i unlock/open my doors only the center dome light turns on, is there a way i can wire in the map lights to do the same function and work with my lock.unlock keys as well? I have LED's all around but i want the front to turn on just like the ex+ models
  18. The 9th Generation
    Ordered both from CollegeHillsHonda Link Below http://www.collegehillshonda.com/honda-accord-sedan-accessories/2013-honda-accord-sedan-accessories.htm Illuminated Footwells [shoes are the Reebok Kamikaze II Mid if anyone was wondering] Illuminated Doorsills
  19. The 7th Generation
    Hello my online alias is Negociator, but you can call me Nego for short. Earlier this fall I bought a used 03 Accord EX-L Coupe. It's an automatic and my first car as I'm only a senior in High School. I loves standards and have driven them before, but my mom forced me into getting an automatic...
  20. The 7th Generation
    Project is more or less finished. You will note that the door is done slightly differently - I was unable to find a binding agent that would hold it, while still being removable if I ever wanted to. All in all, a lot of trial and error. But I can't say I don't like the end result! And in the...
Top