might need hub centric rings if holes are bigger. if they are smaller then you pretty much out of luck unless you run spacers
your front wheel will stick out almost an inch (23mm) inner side only gona go in 3mm
rear inner clearance from rim to strut gona be 9mm less then stock and will stick out 29mm. little more then an inch
if it fits it will look pretty good, more flush then it is now
The rear wheel is pretty large and may rub but it has a good offset so not sure on that. You'll want to be sure the center bore is correct. Eg; Nissan wheels will usually fit on a Honda due to larger center bore, but not the other way around. I wouldn't buy without actually test mounting.
sorry to jack, but what do you guys think of 18x9.5 all the way around with a +38. how will this look as far as sticking out, and will it clear rl caliper.
didn't want to make a new thread cuz i was wondering the same thing. can someone answer this? instead i want to run +15 all around. Can 18x9.5 +15 fit on a 06 coupe lowered about 1 finger gap without any modification to the fenders? thanks in advance
Dont put staggered rims on an accord its front wheel drive,,,,, im not gonna boss saying you should leave them but thats just not right, the belong on a rear wheel drive sorry
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Drive Accord Honda Forums
2M posts
126.2K members
Since 2003
Drive Accord forum, a community where Honda Accord owners can discuss reviews, service, parts, and share mods.