Drive Accord Honda Forums banner
Cancel

Intro, along with P2646 issues

Jump to Latest Follow
1 - 2 of 2 Posts
C

· Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hello my name is Cisco, and I'm new to this community. I own a 92 Accord LX with 80,XXX miles and my wife has a 05 Accord with 100,XXX miles.

The 05 Accord is giving me issues and reading codes P2646, P300, P302, P303. I've cleaned the vtc strainer and the vtec solenoid and still hiccups at 2800 rpms. So I replaced the whole vtec solenoid unit hoping it would fix the problem and it didn't. I've also changed the oil and made sure it wasn't running low on oil.

Any thoughts on what my problems might be? Or what to check next?

Cisco
 
C

· Registered
Joined
·
2 Posts
Discussion Starter · #2 ·
Ok so I hadn't changed the oil filter till today because my oil filter wrench was just a bit bigger then the filter so I bought a oil filter plier and finally replaced it. Some how this fixed the problem I'm guessing the size of the filter effected the oil pressure? Drove the car for about 50 miles and drove normal.

All the misfiring codes cleared except P0301 cylinder1.

Cisco
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
About this Discussion
1 Reply
1 Participant
Last post:
Ciskoe23
Drive Accord Honda Forums
Drive Accord forum, a community where Honda Accord owners can discuss reviews, service, parts, and share mods.
Full Forum Listing
Explore Our Forums
The 8th Generation The 7th Generation The 9th Generation The 10th Generation Audio, Electronics & Lighting
Top