Looks great! How difficult was the NextGen ceramic coating to apply?
Also, your hood looks slightly lower than the fender up by the cowl on the driver’s side like mine does. I wonder if there is a way to adjust it up there. All I see on mine is the hinge with bolts going through to attach the hood. No rubber bumpers at the cowl either. I already tried the side adjustment rubber bumper near the marker light, but it didn’t do anything for the rear edge near the cowl.
Thank you kindly.
you are correct in that the hood is low on the drivers side corner near the cowl. I thought about giving it a bend, but the hood is pretty solid and I know with my luck, the paint would crack. So I digressed. Both rear doors are more noticeable to my eye since the body line doesn’t line up well. I may mess with the hinges someday.
The NexGen was easy to apply. Mist it on, rub it in, then buff with microfiber towels till glossy and no streaks. I did all the exterior panels, and the glass on both sides (will do windshield and rear glass next wash day) in just under two hours.
No direct Sun or hot panels while applying. You do not want it to dry according to the application directions.
I bought a 36 pack of the yellow microfiber towels at Costco for the job. Fifty cents a towel was a good investment
