Drive Accord Honda Forums banner
1 - 17 of 17 Posts

· Registered
Joined
·
41 Posts
Discussion Starter · #1 ·
Just in today.

Magnaflow 10426 Resonator
Magnaflow 11224 Muffler x 2
Magnaflow 35158 Tips x 2
Magnaflow 10748 Y Pipe
All SS Hangers and Clamps
2.5 Inch SS Tube all mandrel bent







 

· Registered
Joined
·
41 Posts
Discussion Starter · #3 ·
Not quite. The largest Magaflow Tips are 4.5" Across, a half inch less than the factory tips. They are also angled down as opposed to the diagonal.

Here's a straighter shot, and close ups:



 

· 13 Accord Coupe V6 Ex-L
Joined
·
239 Posts

· Registered
Joined
·
697 Posts
there is a vid clip linked at the bottom of his first post, albeit poor it's there.
and agreed with glen, the tips need to be redone/angled to match the curvature of the bumper cut outs.
 

· Registered
Joined
·
41 Posts
Discussion Starter · #14 ·
Will post HD stereo video later in the week.

Honestly, I like the tips position. The photos do exaggerate the fact that they're straight as opposed to angled like the stock tips.

There is no drone, and it's fairly quiet until you get on the gas. Pretty much exactly what I was looking for.

No dyno test, but feels pretty good (even if it's my imagination)!

Sent from AutoGuide.com Free App
 

· Registered
Joined
·
2,351 Posts
Sounds good, I've been thinking about replacing my stock resonator w/with an aftermarket... Looks like I will go with Magnaflows


Sent from AutoGuide.com Free App
 

· Retired G-Man
Joined
·
857 Posts
Paint the mufflers and all the welds a flat black hi-temp paint like:

 
1 - 17 of 17 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top