Drive Accord Honda Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
34 Posts
Yeah, they may have done just what I did... installed a new Bosch sensor only to have the P0139 set within about two weeks. Reports are stacking up that non OE sensors just aren't cutting it in this case. Could be a bad production run.

I'm going with the Denso sensor ASAP, and will do a follow up report on the forum just as soon as I get it done, and through a readiness cycle or two.

-R
 

·
Registered
Joined
·
34 Posts
So, the place I bought the Bosch sensor sent me a Standard Motor Products OE style sensor to replace the Bosch. As of right now all's well.

I don't know if the our 05 LX 2.4 has even gotten through its drive cycle and readiness tests have completed, but the MIL has been off for more than three consecutive 15 mile or more trips now, and as of today still error free.

I'll reserve a full review of the "Standard" brand oxygen sensor for a few hundred miles to be sure.

-Roger
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top