I've recently installed and hardwired a front and rear dash cam on my vehicle, but along the way I had a short in slot 15 of the passenger fuse box (driver's seat recline). This was fuse tapped with the 20A recliner fuse (battery power) and with a 15A dash cam fuse. (Too big I know, that's my bad).
The fuse tap's metal end touched the ground bolt and sparked, and the 15A fuse blew. I then replaced it with a 7.5A fuse and finished the dash cam install, which works fine now. The seat recliner also works.
However, the IMID screen no longer comes on at all. And the radio only comes on when the car is in accessory mode. When I go to turn the engine on the radio shuts off and stays off.
There's no other issues with the car as far as I can tell. I've checked the audio fuses in the passenger and under hood fuse box and they're all fine. Tried leaving battery disconnected for 20 minutes to see if it would reset but no luck.
Anybody have any ideas? Thank you
The fuse tap's metal end touched the ground bolt and sparked, and the 15A fuse blew. I then replaced it with a 7.5A fuse and finished the dash cam install, which works fine now. The seat recliner also works.
However, the IMID screen no longer comes on at all. And the radio only comes on when the car is in accessory mode. When I go to turn the engine on the radio shuts off and stays off.
There's no other issues with the car as far as I can tell. I've checked the audio fuses in the passenger and under hood fuse box and they're all fine. Tried leaving battery disconnected for 20 minutes to see if it would reset but no luck.
Anybody have any ideas? Thank you
